Fixes:

• Problem with GUI not always showing up in Nuendo is fixed.
• Small adjustments have been made to improve stability.

New:

• High Cut filter added to provide the fat dark sound found in some old analog chorus.

Fixes:

• Fixed issue where the meter could hang “lit” if the plugin was turned off.
• Fine adjustment key changed from Ctrl to Shift.
• Knob reset key changed from Alt to Ctrl.
• Removed "%" that was added after parameters in some Hosts.
• Possible problem when multiple instances of the same plugin were run resolved.

New:

• Fine adjust knobs by holding down the Ctrl key.
• Reset knob parameters by Alt + left mouse-click.
• After trial time has ended, the plug-in continues to work but with a one second audio dropout every thirty seconds.
• Hyperlink from logo, quickly allowing a check for updates and new products.

Fixes:

• Solved issue where the GUI was invisible and / or wasn’t repainted properly in some hosts and wrappers.
• Solved issue with wrongly reported I/O sampling rate.
• Solved issue where plug-in would report that no GUI was available when requested by the host. This caused one host to not open the GUI.
• Removed irrelevant dialog appearing the first time a plug-in is loaded.
• Improved VU-meter updates.

New:

• Manual updated.

Fixes:

• Problems with graphic update solved.
• Crash when used together with PACE encrypted plugins solved (this issue was introduced in a recent update of PACE).
• A few host related problems solved.
• Tempo code is now shown correctly.

New:

• Linear control of the knobs.
• Reduced noise when delay and depth controls are operated.
• Manual Link on GUI.
• Trial License label removed, registration now done under “About”
• Trailing dot removed from numeric fields.

Fixes:

• Problem with error messages filling up the task bar after more instances of GMO-1 has been loaded and all of them unloaded again have been fixed.
• GUI problem under Logic has been fixed.
• Incorrect oversampling with sampling rates above 48kHz fixed.

Fixes:

• Fixed a minor issue with the way the tempo code was showed.

• When LFO1 is selected on the LFO2 waveform selector the LFO2 Rate field will blank and the pointer will disappear, indicating that the parameter is disabled.
• Preset bank for send and insert effect.

Fixes:

• Fixed the way it obtains sample rate from the host. In some hosts it would not produce any sound due to missing sample rate.
• Sync did not work with very high tempos – now it does.
• The tempo signature is now showed when sync is enabled.

• Bad initialization of a buffer fixed.
• It now works with hosts only supporting the VST1.0 standard (before the host would have to support VST2.0).